Recalls: 1998 - CHEVROLET - MONTE CARLO

• NHTSA Campaign ID Number: 01I014000 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS
  Recall Date: 01/07/2002

  Summary:
  THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1995-1999 CHEVROLET MONTE CARLO Z34 PASSENGER VEHICLES. THE BRAKING PERFORMANCE IN WET WEATHER OR WET ROAD CONDITIONS IS REDUCED MORE THAN A DRIVER WOULD EXPECT.
  
  Manufacturer that filed the Recall:
  GENERAL MOTORS CORP.
  
  Consequence:
  THE BRAKING COULD FEEL DELAYED MOMENTARILY WHEN LIGHT OR MODERATE FORCE IS APPLIED ON THE BRAKE PEDAL WHILE DRIVING ON WET ROADS OR AFTER GOING THROUGH A CAR WASH.
  
  Remedy:
  DEALER WILL MODIFY THE FRONT FENDER LINERS TO REMOVE A PORTION OF THE CLOSEOUT PANELS IN THE FRONT WHEEL WELLS AT NO CHARGE TO THE CONSUMER. THIS SERVICE WILL BE AVAILABLE THROUGH AUGUST 2004.

• NHTSA Campaign ID Number: 03V527000 - STEERING:RACK AND PINION
  Recall Date: 12/18/2003

  Summary:
  CERTAIN PASSENGER VEHICLES HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE RETAINERS COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.
  
  Manufacturer that filed the Recall:
  GENERAL MOTORS CORP.
  
  Consequence:
  IF THIS OCCURS, THE PINION SHAFT CAN BE FORCED UPWARD DURING LEFT TURNS AND BACK DOWN AS THE STEERING WHEEL IS MOVED BACK AND TO THE RIGHT. IF THE PINION SHAFT MOVES FURTHER, THE DRIVER WILL NEED TO EXERT MORE EFFORT TO TURN THE STEERING WHEEL, SIMILAR TO A VEHICLE WITHOUT POWER ASSISTED STEERING. IF THE PINION SHAFT MOVES EVEN FURTHER, THE DRIVER WILL REQUIRE MUCH HIGHER EFFORT TO TURN LEFT AND MAY NOT BE ABLE TO TURN THE WHEEL AS MUCH AS INTENDED. WITH THE MAXIMUM PINION SHAFT MOVEMENT, WHICH REQUIRES INTERNAL GEAR COMPONENT DAMAGE, THE DRIVER CAN ENCOUNTER HIGH RESISTANCE TO TURNING LEFT, FOLLOWED BY UNINTENDED POWER ASSIST TO THE RIGHT. IN ANY OF THESE CONDITIONS, A CRASH COULD OCCUR.
  
  Remedy:
  DEALERS WILL INSTALL A NEW LOWER PINION BEARING UNLESS INSPECT OF THE EXISTING BEARING INDICATES THAT REPLACEMENT OF THE GEAR ASSEMBLY IS NECESSARY. OWNER NOTIFICATION BEGAN ON FEBRUARY 5, 2004. OWNERS SHOULD CONTACT BUICK AT 1-866-608-8080; CHEVROLET AT 1-800-630-2438; OLDSMOBILE AT 1-800-630-6537; OR PONTIAC AT 1-800-620-7668.

• NHTSA Campaign ID Number: 07E021000 - FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY:PRESSURE RELIEF DEVICES
  Recall Date: 03/12/2007

  Summary:
  CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.
  
  Manufacturer that filed the Recall:
  GENERAL MOTORS CORP.
  
  Consequence:
  FUEL MAY LEAK, POSSIBLY RESULTING IN A FIRE.
  
  Remedy:
  DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.