Recalls: 1993 - PLYMOUTH - COLT

• NHTSA Campaign ID Number: 97V063002 - LATCHES/LOCKS/LINKAGES:DOORS:LATCH
  Recall Date: 05/23/1997

  Summary:
  EXCESS LUBRICATION CAN CAUSE THE RUBBER DOOR LATCH SWITCH COVER TO DEFORM, AND THE DOOR LATCH SWITCH TO MALFUNCTION, SO THAT THE SHOULDER BELT ANCHORAGE WOULD REMAIN AT THE A-PILLAR WHEN THE DOOR WAS CLOSED.
  
  Manufacturer that filed the Recall:
  CHRYSLER LLC
  
  Consequence:
  IN THE EVENT OF A CRASH, THE SEAT OCCUPANT MAY NOT BE PROPERLY RESTRAINED.
  
  Remedy:
  DEALERS WILL REPLACE THE DOOR LATCH SWITCH WITH A SWITCH THAT UTILIZES REDUCED LUBRICATING GREASE, IMPROVED CONTACT SURFACE, AND A DIFFERENT RUBBER ISOLATION BOOT.

• NHTSA Campaign ID Number: 97V073002 - SEAT BELTS:FRONT:ANCHORAGE
  Recall Date: 05/23/1997

  Summary:
  THE GUIDE RAIL ON THE DRIVER'S SIDE CONTAINS A COVERED CABLE AND ALSO AN ANGLED BELT GUIDE AT THE TOP END OF THE WEBBING. THE COMBINATION OF THESE FACTORS CAN LEAD, OVER TIME, TO THE CABLE'S MOVEMENT EXERTING ABRADING FORCE TO THE LOWER EDGES OF THE CABLE'S CHAMBER, SUFFICIENT TO CAUSE THE CABLE TO DROP OUT OF THE CHAMBER WITH THE SHOULDER BELT ANCHORAGE BECOMING STUCK.
  
  Manufacturer that filed the Recall:
  CHRYSLER LLC
  
  Consequence:
  IN THE EVENT OF A CRASH, THE SEAT OCCUPANT MAY NOT BE PROPERLY RESTRAINED.
  
  Remedy:
  DEALERS WILL INSTALL A NEW REPLACEMENT GUIDE RAIL THAT INCORPORATES A DOUBLE LIP DUST SEAL AND AN ANODIC OXIDE COATING.

• NHTSA Campaign ID Number: 98V168003 - POWER TRAIN:AUTOMATIC TRANSMISSION
  Recall Date: 10/07/1998

  Summary:
  VEHICLE DESCRIPTION: ALL WHEEL DRIVE PASSENGER VEHICLES. LOCKUP OF THE TRANSFER CASE CAN OCCUR DUE TO INSUFFICIENT LUBRICATION.
  
  Manufacturer that filed the Recall:
  CHRYSLER LLC
  
  Consequence:
  THIS CONDITION CAN CAUSE A LOSS OF VEHICLE CONTROL, INCREASING THE RISK OF A CRASH.
  
  Remedy:
  DEALERS WILL INSPECT THE VEHICLES FOR ADEQUACY OF THE TRANSFER CASE OIL VOLUME, TRANSFER CASE OIL LEAKAGE, AND OPERATIONAL DEGRADATION OF THE TRANSFER CASE MECHANISM. IF OIL VOLUME IS INSUFFICIENT, THE APPROPRIATE AMOUNT OF OIL WILL BE ADDED. IF THERE IS TRANSFER CASE OIL LEAKAGE, AFFECTED COMPONENTS WILL BE REPLACED. IF THE TRANSFER CASE SHOWS OPERATIONAL DEGRADATION, THE TRANSFER CASE WILL BE REPLACED.