Recalls: 1993 - FREIGHTLINER - FL-70

• NHTSA Campaign ID Number: 93V104000 - SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:CALIPER
  Recall Date: 06/22/1993

  Summary:
  AS THE BRAKE PADS WEAR, THE BRAKE CALIPER TRAVEL MAY BE LIMITED BY INTERFERENCE WITH THE MAIN SUPPORT MEMBER (Z-BAR SPRING) OF THE SUSPENSION.
  
  Manufacturer that filed the Recall:
  FREIGHTLINER LLC
  
  Consequence:
  LIMITED BRAKE CALIPER TRAVEL CAN PREVENT FULL BRAKETORQUE APPLICATION ON THE DRIVE AXLE, INCREASING STOPPING DISTANCES.
  
  Remedy:
  BENDIX WILL SUPPLY REPLACEMENT BRAKE CALIPERS FOR AFFECTED VEHICLES.

• NHTSA Campaign ID Number: 95E003005 - SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS
  Recall Date: 09/27/1995

  Summary:
  AIR SYSTEM BLOCKAGE IN THE AIR DRYER OCCURS DEGRADING THE MOISTURE REMOVING CAPABILITIES OF THE DRYER WHEN THE VEHICLE IS OPERATED IN A COLD ENVIRONMENT AND MOISTURE ACCUMULATES AND FREEZES IN THE AIR DRYER OR IN THE LINE BETWEEN THE DRYER AND THE AIR SYSTEM RESERVOIR. THE AIR DRYER CAN BECOME OVER PRESSURIZED CAUSING THE AIR DRYER CARTRIDGE TO SEPARATE FROM THE MOUNTING BASE.
  
  Manufacturer that filed the Recall:
  FREIGHTLINER LLC
  
  Consequence:
  IF THE AIR DRYER SEPARATES FROM THE BASE, THE CARTRIDGECAN SEPARATE SUFFICIENTLY ENOUGH TO CAUSE PERSONAL INJURY OR PROPERTY DAMAGE.
  
  Remedy:
  DEALERS WILL EQUIP AIR SYSTEMS WITH A PRESSURE RELIEF VALVE TO BE LOCATED BETWEEN THE COMPRESSOR AND THE AIR DRYER. THIS PRESSURE RELIEF VALVE IS INTENDED TO VENT IF EXCESSIVE PRESSURE DEVELOPS IN THE AIR DRYER.

• NHTSA Campaign ID Number: 95V018000 - SERVICE BRAKES, AIR:DRUM:CHAMBER
  Recall Date: 02/22/1995

  Summary:
  THE BRAKE CHAMBER MOUNTING STUDS CAN LOOSEN OR PULL THROUGH DUE TO FATIGUE IN THE BRAKE CHAMBER HOUSING CAUSED BY FOUNDATION BRAKE CHATTER.
  
  Manufacturer that filed the Recall:
  FREIGHTLINER LLC
  
  Consequence:
  THIS CONDITION CAN RESULT IN LOSS OF BRAKING CAPABILITY.
  
  Remedy:
  DEALERS WILL CHANGE THE BRAKE LINING MATERIALS, REPLACE THE WING BRACKET WITH A REINFORCED BRACKET AND INSTALL BRAKE CHAMBERS WITH REINFORCED CHAMBER HOUSING AND LARGER (1/2") MOUNTING STUDS.

• NHTSA Campaign ID Number: 95V094000 - PARKING BRAKE:CONVENTIONAL:MECHANICAL
  Recall Date: 05/19/1995

  Summary:
  THE PARKING BRAKE LEVER MAY NOT TRAVEL FAR ENOUGH OVER CENTER TO ASSURE THAT IT REMAINS IN THE PROPER POSITION ALLOWING THE VEHICLE TO ROLL AWAY WHILE PARKED.
  
  Manufacturer that filed the Recall:
  FREIGHTLINER LLC
  
  Consequence:
  IF THE VEHICLE IS NOT PROPERLY PARKED WITH THE TRANSMISSION IN THE CORRECT POSITION, AND IF THE VEHICLE IS PARKED ON A GRADE, IT COULD UNINTENTIONALLY ROLL AWAY INCREASING THE POTENTIAL FOR AN ACCIDENT.
  
  Remedy:
  DEALERS WILL REMOVE AND REPLACE THE PARKING BRAKE LEVER WITH A LEVER THAT REQUIRES A 25 LB. EFFORT TO RELEASE.

• NHTSA Campaign ID Number: 97V114001 - EXTERIOR LIGHTING:TURN SIGNAL:SWITCH
  Recall Date: 08/06/1997

  Summary:
  VEHICLE DESCRIPTION: HEAVY DUTY TRUCK. THE SHOULDER BOLT WHICH HOLDS THE GROTE TURN SIGNAL SWITCH CASE AND COMPONENTS TOGETHER CAN LOOSEN RESULTING IN THE TURN SIGNAL MALFUNCTIONING.
  
  Manufacturer that filed the Recall:
  FREIGHTLINER LLC
  
  Consequence:
  IF THE TURN SIGNAL FUNCTION IS LOST, FOLLOWING MOTORISTS WOULD NOT BE AWARE OF THE TURNING VEHICLE, INCREASING THE RISK OF A VEHICLE CRASH.
  
  Remedy:
  DEALERS WILL INSPECT THESE VEHICLES AND TIGHTEN ANY LOOSE BOLTS AND IN THE TURN SIGNAL SWITCH WITHIN 2 YEARS FROM THE DATE OF THE RECALL NOTIFICATION LETTER. THE SHOULDER BOLT WILL BE REMOVED, CLEANED, AND REINSTALLED WITH LOCTITE. OWNERS CAN ALSO REQUEST LOCTITE AND REPAIR INSTRUCTIONS SO THEY CAN FIX THE VEHICLES THEMSELVES.