Recalls: 1990 - LINCOLN - TOWN CAR

• NHTSA Campaign ID Number: 90V133000 - EQUIPMENT:OTHER:LABELS
  Recall Date: 07/31/1990

  Summary:
  TIRE PLACARD MAY CONTAIN INCORRECT GROSS VEHICLE WEIGHT RATINGS AND TIRE INFORMATION.
  
  Manufacturer that filed the Recall:
  GENERAL MOTORS CORP.
  
  Consequence:
  LIMOUSINES WOULD NOT COMPLY WITH FMVSS 110 AND CONSUMERMIGHT UNKNOWINGLY OVERLOAD THE VEHICLE BECAUSE OF PLACARD MISINFORMATION.
  
  Remedy:
  INSTALL REVISED TIRE PLACARDS.

• NHTSA Campaign ID Number: 90V134000 - EQUIPMENT:OTHER:LABELS
  Recall Date: 07/31/1990

  Summary:
  GROSS VEHICLE WEIGHT RATINGS AND TIRE INFORMATION MAY BE INCORRECT ON LABELS.
  
  Manufacturer that filed the Recall:
  GENERAL MOTORS CORP.
  
  Consequence:
  VEHICLES WOULD NOT COMPLY WITH 49 CFR PART 567.
  
  Remedy:
  INSTALL REVISED CERTIFICATION LABELS.

• NHTSA Campaign ID Number: 95V091000 - LATCHES/LOCKS/LINKAGES:HOOD:LATCH
  Recall Date: 05/18/1995

  Summary:
  CORROSION OF THE HOOD LATCH STRIKER PLATE CAUSES DETACHMENT OF THE PLATE FROM THE HOOD ASSEMBLY RESULTING IN AN UNEXPECTED OPENING OF THE HOOD WHILE THE VEHICLE IS BEING DRIVEN.
  
  Manufacturer that filed the Recall:
  FORD MOTOR COMPANY
  
  Consequence:
  THIS CONDITION CAN REDUCE THE DRIVER'S VIEW OF THE ROAD INCREASING THE POTENTIAL OF A VEHICLE ACCIDENT.
  
  Remedy:
  DEALERS WILL INSTALL A NEW HOOD INNER PANEL REINFORCEMENT AND A NEW, GALVANIZED HOOD LATCH STRIKER PLATE.

• NHTSA Campaign ID Number: 98V322000 - SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT
  Recall Date: 12/18/1998

  Summary:
  VEHICLE DESCRIPTION: CERTAIN 1996-1999 FORD CROWN VICTORIA POLICE, FLEET, NATURAL GAS, AND 1996-1999 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT WERE PRODUCED WITH A LOWER CONTROL ARM BALL JOINT CONTAINING A ONE PIECE BEARING; AND 1990-1996 FORD CROWN VICTORIA POLICE, FLEET, AND NGV VEHICLES AND 1990-1996 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT HAVE BEEN SERVICED WITH EITHER A BALL JOINT CONTAINING THE ONE-PIECE BEARING OR A FRONT LOWER CONTROL ARM CONTAINING A BALL JOINT WITH A ONE-PIECE BEARING. THE ONE-PIECE BEARING WITHIN THE LOWER CONTROL ARM BALL JOINT CAN WEAKEN SLOWLY DURING USE AND EVENTUALLY CRACK. THIS COULD RESULT IN SEPARATION OF THE BALL AND CAP OF THE JOINT, ALLOWING THE CONTROL ARM TO DROP TO THE GROUND.
  
  Manufacturer that filed the Recall:
  FORD MOTOR COMPANY
  
  Consequence:
  IF THIS OCCURS WHILE THE VEHICLE IS MOVING, REDUCED STEERING CONTROL COULD OCCUR, INCREASING THE RISK OF A CRASH.
  
  Remedy:
  DEALERS WILL REPLACE THE LOWER CONTROL ARM BALL JOINTS (2).